Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
3.8.2 Rear Wheel Housing Liner
1 - Rear Wheel Housing Liner
• Rear wheel removed.
❑ Removing
– Vehicles without an ex‐
panding clip: remove
nuts
⇒ Item 2 (page 256)
and bolts
⇒ Item 3 (page 256) .
– Vehicles with an ex‐
panding clip
⇒ page 256
– Remove wheel housing
liner downward.
❑ Installation: in reverse
order.
2 - Nut
❑ 2 Nm
3 - Screws
❑ 1.5 Nm
4 - Side panel
5 - Expanding nut
❑ Pressed into side panel.
Rear Wheel Housing Liner with Expanding Clip
– Remove the screws -arrows- from the wheel housing liner and
remove expanding clip -3-.
– To remove the expanding clip, press in clamping pin -1- care‐
fully by dimension -x- until it audibly engages in the expanding
clip -arrow A-.
• Dimension -x- = 5 mm
– Pull out unlocked expanding clip -2- with the clamping pin.
Audi TT 2007 ➤
Body Exterior - Edition 11.2010
256 Rep. Gr.66 - Exterior Equipment
To Next Page
Loading...
