Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Flap Trim, Disengaging
– Using a small screwdriver, for example, press retainer
-arrow- down and slide trim -2- back away from flap -1-.
– For side adjustment to flap, loosen bolts -3- and slide flap car‐
rier -1- according to gap dimensions.
Flap Gap Dimensions
♦ Dimension »a« = 3.6 mm
♦ Dimension »b« = 3.6 mm
♦ Dimension »c« = 3.6 mm
Height Adjustment to Side Panel
– Height to side panel is adjusted using adjusting screws
-arrows-.
Audi TT 2007 ➤
Body Exterior - Edition 11.2010
126 Rep. Gr.61 - Convertible Top
To Next Page
Loading...
