Audi TT 207 - Impact Member, Shock Absorber and Guide Piece Assembly Overview

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
❑ 2 Nm
1.4.2 Impact Member, Shock Absorber and Guide Piece Assembly Overview
1 - Impact absorber
❑ Removing and Instal‐
ling, refer to
⇒ “2.4.5 Impact Absorb‐
er“, page 186
2 - Bolt
❑ Quantity: 7
❑ 23 Nm
3 - Bolt
❑ Quantity: 2
❑ For the correct tighten‐
ing specifications, refer
to ⇒ Item 10 (page 160)
4 - Left holder for bumper
❑ Removing and Instal‐
ling, refer to
⇒ “2.4.7 Rear Bumper
Bracket“, page 187
5 - Nut
❑ Quantity: 2
❑ 4 Nm
6 - Bolt
❑ Quantity: 6
❑ Tightening Specifica‐
tions and Sequence
⇒ page 162
7 - Left inner guide piece
❑ Removing and Instal‐
ling, refer to
⇒ “2.4.9 Inner Guide
Piece“, page 188
8 - Bolt
❑ Quantity: 2
❑ 2 Nm
9 - Guide piece holder
10 - Nut
❑ Quantity: 2
❑ Tightening Specifications and Sequence ⇒ page 162
11 - Left guide piece
❑ Removing and Installing, refer to ⇒ “2.4.8 Guide Piece“, page 187
12 - Bolt
❑ Quantity: 6
❑ Tightening Specifications and Sequence ⇒ page 162
13 - Right guide piece
❑ Removing and Installing, refer to ⇒ “2.4.8 Guide Piece“, page 187
Audi TT 2007 ➤
Body Exterior - Edition 11.2010
1. Description and Operation 161