Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
1.1.3 Door Lock Assembly Overview
1 - Cover
❑ Pressed into door.
❑ When removing, unclip
from lock cylinder and
remove bolt below.
2 - Bolt
❑ 20 Nm.
3 - Door
4 - Door lock
❑ Removing
❑ Door trim removed, re‐
fer to ⇒ Body Interior;
Rep. Gr. 70 ; Removal
and Installation
❑ Rear cover on inner
panel removed
⇒ page 90
– Raise window up.
– Lock cylinder removed.
– Remove bolts -2- and
slide door lock down.
– Disengage internal
mechanism cable -7-
from door lock.
❑ Install in reverse se‐
quence.
5 - Lock cylinder shaft
❑ So-called »paddle«
must be guided into
groove -arrow- in door
lock during installation
6 - Lock cylinder
7 - Inside door release mechanism cable
Internal mechanism cable, engaging in door lock
– To install, first insert release cable -2- vertically into release
lever -3- as shown in the magnified area of illustration, then
swivel 90° and clip into door lock -1- to secure.
Audi TT 2007 ➤
Body Exterior - Edition 11.2010
78 Rep. Gr.57 - Front Doors, Central Locking System
To Next Page
Loading...
