Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
2.2.2 Door Handle and Door Lock
1 - Door lock
• Door trim removed. Refer
to ⇒ Body Interior; Rep. Gr.
70 ; Removal and Installa‐
tion .
❑ The door lock can be re‐
moved without remov‐
ing window regulator.
❑ Removing, refer to
⇒ “1.1.3 Door Lock As‐
sembly Overview“, page
78
2 - Bolt
❑ 20 Nm
3 - Anti-theft cover
❑ Slid onto door panel
⇒ page 97
4 - Bracket
• Removing and installing
with door handle and lock
cylinder handle removed.
• Cable, disengaging at door
lock
❑ To remove, remove the
bolt -11-, slide mounting
bracket slightly to rear
and remove from door.
5 - Actuating link
❑ Engage in door lock
⇒ Item 3 (page 76)
6 - Rear backing
❑ Insert in door panel
7 - Lock cylinder housing
❑ Removing
– Unclip cover cap on front side of door.
– Remove door handle.
– Remove bolt as far as stop using socket wrench (AF T20).
– With light pressure on bold, release lock cylinder and remove sideways from door.
❑ Installing:
– Cover cap -8- must be attached before installing.
8 - Cover
❑ Attached to lock cylinder.
9 - Door handle
10 - Front backing
❑ Attach to door handle.
Audi TT 2007 ➤
Body Exterior - Edition 11.2010
96 Rep. Gr.57 - Front Doors, Central Locking System
To Next Page
Loading...
