Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
1.4 Rear Lid - Roadster
⇒ “1.4.1 Rear Lid, Adjusting“, page 20
⇒ “1.4.2 Release Cable, Engaging in Rear Lid Lock“, page 21
⇒ “1.4.3 Release Cable Coupling“, page 22
⇒ “1.4.4 Release Cable Routing on Hinge“, page 23
⇒ “1.4.5 Release Cable, Engaging in Handle“, page 24
1.4.1 Rear Lid, Adjusting
Special tools and workshop equipment required
♦ Adjusting gauge -3371-
Gap Dimensions
The gap dimensions can be checked with the Adjustment Gauge
-3371- .
• In -A- area = 4.5 mm +/- 0.5 mm
• In -B- area = 3.5 mm +/- 0.5 mm
• In -C- area = 4.0 mm +/- 0.5 mm
• In -D- area = 2.0 mm +/- 0.5 mm
• In -E- area = 2.0 mm +/- 0.5 mm
Gap Dimensions
♦ Dimension -A- = 4.0 mm +/- 0.5 mm
♦ Dimension -B- = 4.5 mm +/- 0.5 mm
♦ Dimension -C- = 3.5 mm +/- 0.5 mm
♦ Dimension -D- = 2 mm all around
Audi TT 2007 ➤
Body Exterior - Edition 11.2010
20 Rep. Gr.55 - Hood, Lids
To Next Page
Loading...
