Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Gas-Filled Strut, Releasing Gas
– Clamp gas-filled strut in a vise in area -x- = 50 mm (2 in.).
WARNING
♦ Clamp only within this area, otherwise accident could oc‐
cur!
♦ Wear protective eyewear when sawing.
Note
Cover area of sawn portion with a rag to absorb oil spraying out.
– Cut through the gas-filled strut cylinder within the first third of
the overall cylinder length using the piston rod end of the cyl‐
inder as a reference point.
2.1.6 Front Hood Lock Release Cable
1 - Front hood lock
❑ Removing and installing
❑ To adjust the hood, slide
up or down.
2 - Release cable for front
hood lock
❑ Removing
❑ Cable, disconnecting at
coupling ⇒ page 33
– Disengage cable from
bracket -7-.
– Pull cable through to en‐
gine compartment.
❑ Installation: in reverse
order.
3 - Foam tube
❑ Slid onto coupling
4 - Cable coupling
❑ Disconnect cable here
before removing lock
carrier and release lev‐
er.
5 - Grommet
❑ Ensure correct seating
when installing.
6 - Cable cover
❑ Slid onto panel edge.
7 - Cable bracket
❑ Cable, disengaging
⇒ page 36
8 - Hood lock release lever
❑ Release lever cover, removing ⇒ page 35
Audi TT 2007 ➤
Body Exterior - Edition 11.2010
2. Removal and Installation 31
To Next Page
Loading...
