Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
55 – Hood, Lids
1 Description and Operation
⇒ “1.1 Hood - TT“, page 10
⇒ “1.2 Hood - TT RS“, page 12
⇒ “1.3 Rear Lid - Coupe“, page 18
⇒ “1.4 Rear Lid - Roadster“, page 20
1.1 Hood - TT
⇒ “1.1.1 Hood, Adjusting“, page 10
⇒ “1.1.2 Hood Hinge, Adjusting“, page 11
1.1.1 Hood, Adjusting
Special tools and workshop equipment required
♦ Adjusting Gauge -3371-
Gap Dimensions for Hood
• In -A- area = 3.5 mm +/- 0.5 mm.
• In -B- area = 4.5 mm +/- 0.5 mm
• In -C- area = 4.5 mm +/- 0.5 mm
• In -D- area = 4.0 mm to 2.5 mm (in transition area)
• In -E- area = 3.5 mm +/- 0.5 mm
• In -F- area = 3.5 mm +/- 0.5 mm
Buffer Stop for Height Adjustment
• Adjusting buffer -1- must lightly contact the lock carrier when
the lid is closed.
• Rubber buffers -2- act as a strike guard and should not make
contact with the lid closed.
Note
The adjusting buffers are used to adjust the height of the lid.
Audi TT 2007 ➤
Body Exterior - Edition 11.2010
10 Rep. Gr.55 - Hood, Lids
To Next Page
Loading...
