Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
♦ Objects in the convertible top compartment must be removed
to prevent the convertible top and rear window from being
damaged.
1.1.5 Convertible Top Assembly Overview
1 - Convertible top
❑ Removing and instal‐
ling, refer to
⇒ “2.1.3 Convertible
Top“, page 120
2 - Tensioning strap
❑ Bolted under converti‐
ble top compartment
from luggage compart‐
ment out
3 - Hydraulic System
❑ Must be removed when
installing convertible
top.
4 - Screws
❑ 36 Nm
5 - Spring
❑ Bracket securing spring.
6 - Bracket
❑ Must be removed before
removing convertible
top.
❑ Loosen spring and re‐
move bracket sideways
from retaining pins.
7 - Convertible top frame cover
❑ Removing and instal‐
ling, refer to
⇒ “2.1.7 Convertible
Top Frame Flap“,
page 125
8 - Rear convertible top com‐
partment trim
❑ When removing the convertible top, only disengage at the rear bracket
⇒ “2.1.5 Bracket, Disengaging at Main Bearing“, page 123 .
9 - Convertible top release
❑ Only on manual convertible top.
10 - Clip
❑ Quantity: 12
Audi TT 2007 ➤
Body Exterior - Edition 11.2010
1. Description and Operation 109
To Next Page
Loading...
