Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
2.1.8 Air Grille
Removing
– Remove grille -1- from bumper -2- beginning at outside.
– When installing, retaining tabs -arrows- must engage com‐
pletely in bumper.
2.2 Front Bumper - Audi TT RS
⇒ “2.2.1 Front Bumper“, page 170
⇒ “2.2.2 Front Bumper Guide Piece“, page 172
⇒ “2.2.3 Air Intake Grille“, page 172
⇒ “2.2.4 Inner Cover“, page 173
⇒ “2.2.5 Spoiler Upper Part“, page 173
⇒ “2.2.6 Spoiler Lower Part“, page 173
⇒ “2.2.7 Impact Absorber“, page 174
⇒ “2.2.8 Impact Member“, page 174
2.2.1 Front Bumper
Special tools and workshop equipment required
♦ Engine bung set -VAS 6122-
♦ Socket -T40078-
Removing
– Unscrew the screws -arrows- and pull back the wheel housing
liner in the lower area.
Audi TT 2007 ➤
Body Exterior - Edition 11.2010
170 Rep. Gr.63 - Bumpers
To Next Page
Loading...
