Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
2.1.14 Convertible Top Cover Tension Cable, Disengaging
1 - Front rail
2 - Tension cable
❑ First disengage tension
cable at spring.
❑ Disengage tension ca‐
ble at front rail and re‐
move back from conver‐
tible top cover.
3 - Convertible top cover
4 - Adhesive tape
❑ After installing the ten‐
sion cable, tape it over
with adhesive tape as
shown for noise insula‐
tion.
5 - Main guide
6 - Spring
2.1.15 Tension Cable, Tightening
Note
Make a hook from welding wire to help tighten the tension cable.
– With manual convertible top cover, slide hook -1- up into pock‐
et, or with automatic convertible top, in direction of arrow
between cover and insulation.
Audi TT 2007 ➤
Body Exterior - Edition 11.2010
132 Rep. Gr.61 - Convertible Top
To Next Page
Loading...
