Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
1.2 Hood - TT RS
⇒ “1.2.1 Hood Assembly Overview“, page 12
⇒ “1.2.2 Hood Gap Dimensions“, page 13
⇒ “1.2.3 Hood, Adjusting“, page 14
⇒ “1.2.4 Hood Locks Assembly Overview“, page 16
⇒ “1.2.5 Hood Control Cable, Control Cable Operating Lever As‐
sembly overview“, page 17
⇒ “1.2.6 Hood Lock Cables, Adjusting“, page 18
1.2.1 Hood Assembly Overview
1 - Anti-rotation protection
❑ For the striker pin
❑ Removing and Instal‐
ling, refer to
⇒ “2.2.4 Left and Right
Striker Pins“, page 40
2 - Bolt
❑ 2 Nm
3 - Hood catch
❑ Removing and Instal‐
ling, refer to
⇒ “2.2.4 Left and Right
Striker Pins“, page 40
❑ Adjusting, refer to
⇒ “1.2.3 Hood, Adjust‐
ing“, page 14
4 - Hood
❑ Removing and Instal‐
ling, refer to
⇒ “2.2.1 Hood“,
page 38
5 - Nuts
❑ 9 Nm
6 - Striker pin with catch
❑ Removing and Instal‐
ling, refer to
⇒ “2.2.3 Striker Pin with
Catch“, page 39
7 - Rubber stop
8 - Adjusting buffer
❑ Adjusting, refer to
⇒ “1.2.3 Hood, Adjust‐
ing“, page 14
9 - Impact guard
❑ Removing and Installing, refer to ⇒ “2.2.5 Impact Guard“, page 40
10 - Hood hinge
❑ Removing and Installing, refer to ⇒ “2.2.2 Hood Hinge“, page 39
11 - Bolt
❑ Pay attention to different lengths.
❑ 34 Nm
Audi TT 2007 ➤
Body Exterior - Edition 11.2010
12 Rep. Gr.55 - Hood, Lids
To Next Page
Loading...
