Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
A - Hood to fender - headlamp
area
• Gap dimension-a- = 2.5 +/-
0.5 mm
-1- hood
-2- fender - front area
❑ Adjusting, refer to
⇒ “1.2.3 Hood, Adjust‐
ing“, page 14
B - Hood to front door
• Gap dimension -b- = 3.5 +/-
0.5 mm
• Projection -c- = 0.0 + 1.0
mm
-1- hood
-3- Front door
❑ Adjusting, refer to
⇒ “1.2.3 Hood, Adjust‐
ing“, page 14
C - Hood to fender - A-pillar
area
• Gap dimension -d- = 3.5 +/-
0.5 mm
• Projection -e- = 2.0 +/- 0.5
mm
-1- hood
-4- fender - rear area
❑ Adjusting, refer to
⇒ “1.2.3 Hood, Adjust‐
ing“, page 14
1.2.3 Hood, Adjusting
Special tools and workshop equipment required
♦ Adjustment gauge -3371-
Audi TT 2007 ➤
Body Exterior - Edition 11.2010
14 Rep. Gr.55 - Hood, Lids
To Next Page
Loading...
