Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
3.2.2 Mirror Housing
1 - Mirror housing
❑ Remove mirror glass
before removing.
Removing
– Disconnect mirror motor
and mirror heating elec‐
trical connectors.
– Fold mirror all the way
forward.
– Remove bolt -6- on mir‐
ror base.
– Remove housing up‐
ward from mirror base.
❑ Installation is reverse of
removal, noting the fol‐
lowing:
Note
– When installing, hous‐
ing must be pressed
completely onto hous‐
ing base before it is fol‐
ded back.
2 - Bolt
❑ 2 Nm
3 - Carrier plate
4 - Bolt
❑ 6.5 Nm
5 - Mirror base housing
❑ Mirror housing removed
❑ Remove bolts -4- and remove mirror base over mirror adjusting cable.
6 - Bolt
❑ 6.5 Nm
7 - Mirror adjusting unit
8 - Mirror glass
Audi TT 2007 ➤
Body Exterior - Edition 11.2010
3. Removal and Installation 233
To Next Page
Loading...
