Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Installation
Installation is reverse of removal, noting the following:
– For overflow hose to be routed without kinking, fuel filler door
cup must be installed as follows:
• The edge of the drain hole in the flap cup must align with the
edge of the hole in the body -arrows- as shown in the illustra‐
tion.
2.5.2 Fuel Filler Door Drain Hose
1 - Drain hose
– Press in drain hose un‐
der wheel housing line
into clips -3- as show
and position on body
pins.
2 - Fuel filler door
3 - Clips
❑ Attached to body pins as
shown.
Audi TT 2007 ➤
Body Exterior - Edition 11.2010
70 Rep. Gr.55 - Hood, Lids
To Next Page
Loading...
