Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Adjustment to side window
– Slide template as show between guide rail -4- on side window
-1- and door window -2- into door seal -3-.
– The door window must be in the area of the small groove.
Gap dimensions
The gap dimensions can be checked with the Adjustment Gauge
-3371- .
• Dimension -A- = 3.5 mm +/- 0.5 mm
• Dimension -B- = 3.5 mm +/- 0.5 mm
• Dimension -C- = 0 mm to -1 mm.
• Dimension -D- = 0 mm to +1 mm
Adjustment via striker
– Loosen bolts -2-.
– Slide striker -1- until the door shell is flush with the contour of
the chassis.
– Tighten screws to 20 Nm.
Note
The striker should only be adjusted toward the vehicle center and
not height-wise, otherwise the lock can be damaged.
Audi TT 2007 ➤
Body Exterior - Edition 11.2010
1. Description and Operation 75
To Next Page
Loading...
