Avaya IP500 V2 - Page 203

IP500/IP500 V2 Installation Page 203
15-601042 Issue 25i (03 January 2013)IP Office 8.0
System Components: IP500 V2 Control Unit
Ports
Description
AUDIO
3.5mm Stereo jack socket. Used for external music on hold source input.
AUX
If pressed during a restart of the control unit, the control unit skip booting from the /primary folder
on the System SD card. If pressed for more than 5 seconds when a system is running, the control unit
will shutdown for 10 minutes.
CPU
Indicates the status of the control unit.
· Alternate red/green = Starting up.
· Green on = Okay.
· Red on = No software.
· Flashing Red = Error/Shutdown.
EXPANSION
RJ45 socket. Used for direct connection to external expansion modules using the Expansion Interconnect
cable supplied with the expansion module.
EXT O/P
3.5mm Stereo jack socket. Used for switching external relay systems such as door entry controls. The
port contains two independent switches controlled by the IP Office.
INPUT
AC power input port.
LAN
RJ45 socket. The port is a full-duplex 10/100Mbps auto-sensing, MDI crossover port. With the WAN port
forms a managed layer 3 Ethernet switch.
Optional SD
Used for the Optional SD card. The LED is used in the same way as for the System SD (see below).
RESET
This switch is used to restart the IP Office, optionally erasing the configuration and or the core software in
the process. See Reset Button .
RS232
9-Way D-Type socket. Used for system maintenance.
System SD
Used for the System SD card,. The LED is used as follows.
· Off = Card shutdown .
· Green on = Card present.
· Green flashing = Card in use.
· Orange steady = Reset imminent.
· Red flashing = Card initializing or shutting down.
· Red fast flashing = card full
· Red steady = Card failure/wrong type.
WAN
RJ45 socket. The port is a full-duplex 10/100Mbps auto-sensing, MDI crossover port. With the WAN port
forms a managed layer 3 Ethernet switch. This port is not supported on systems running in IP Office Basic
Edition - PARTNER® Mode, IP Office Basic Edition - Norstar Mode or IP Office Basic Edition - Quick Modes.
Used for connection of a functional or protective ground . Use of a ground for all systems is
recommended and for some locales may be a regulatory requirement.
378
157 157
119
384
137
35
385
154
145
145
146
154
170
385
91