IP500/IP500 V2 Installation Page 228
15-601042 Issue 25i (03 January 2013)IP Office 8.0
9.5.1 Analog Trunk 16
The IP500 Analog Trunk module can be used to add 16 additional analog trunks to an IP Office system. The module
supports both loop-start and, with suitable grounding, ground-start trunks.
· In IP Office Basic Edition - PARTNER® Mode, IP Office Basic Edition - Norstar Mode and IP Office Basic Edition -
Quick Modes, only 1 Analog Trunk module is supported.
· IMPORTANT
In all IP Office installations, any module being used for analog trunk connections must be connected to a functional
earth .
· WARNING
Within areas of high lightning risk, any module using analog trunk connections must be connected to a protective
ground and to surge protection equipment (an Avaya 146G Surge Protector).
This module is currently only supported in North American locales.
IP Office core software level 1.0 minimum. Bin file = naatm16.bin.
Power supply unit (see below) and Expansion Interconnect cable.
The module is supplied with a 2-pin, 40W external power supply unit. The PSU has an integral
power cord for connection to the module's DC I/P socket. A locale specific IEC60320 C7 power cord
for the external PSU is required but is not supplied with the module.
The module is designed as a free-standing module that can be stacked on or under other IP Office
modules. The module can be rack mounted in a 19" rack system using the optional IPO IP500 RACK
MNTG KIT. It can be wall mounted using the IPO IP500 RACK MNTG KIT V2.
Width: 445mm/17.5". Depth: 245mm/9.7". Height: 71mm/2.8"/2U.
Unboxed: 2.9Kg/6.6lbs. Boxed: 4.2Kg/9.4lbs.
39
39 40
34
To Next Page
Loading...
