IP500/IP500 V2 Installation Page 238
15-601042 Issue 25i (03 January 2013)IP Office 8.0
IPO 500 Phone Connections
DC power input port. Used for connection of the power lead from an Avaya earthed 60W external power
supply unit supplied with the expansion module. A locale specific IEC60320 C13 power cord for the
external PSU is required but is not supplied with the module.
9-Way D-Type socket. For Avaya use only.
RJ45 Socket. Used for direct connection to an Expansion port on an IP Office control unit using the
Expansion Interconnect cable supplied with the module.
RJ45 socket. Used for connection of analog phones. Intended for two-wire analog phones. For
connection to 4-wire analog phones connection should be via a master socket with ringing capacitors.
If connected to an out-of-building extension , the connection must be made via additional IP Office
Barrier Boxes in addition to the buildings primary protection. The module must also be connected to
a protective ground.
Protective Ground point. Use of a protective ground is required for all installations, see Grounding
(Earthing) . Where the module is connected to analog extensions in another building, an IP Office
Phone Barrier Box V2 (101V) is required at both ends, see Lightning Protection/Out-of-Building
Connections .
All expansion modules are supplied with a base software level and should be upgraded to match the core software of the
control unit in the IP Office system.
IPO IP500 EXP MOD PHONE 16
IPO IP500 EXP MOD PHONE 30
IPO IP500 RACK MNTG KIT V2
IPO PHONE BARRIER BOX (101V) RHS
Expansion modules include an external power supply unit (PSU) and an appropriate interconnect cable. They do not
include a locale specific power cord for the external PSU or any phone extension cables.
381
34
146
384
387
40
135
39
40
To Next Page
Loading...
