Avnet Qseven MSC Q7-BT - Firmware Update

MSC Q7-BT MSC_Q7-BT_User_Manual.pdf 58 / 113
7.7.3 Firmware Update
Table 7-7 BIOS Hardware Monitoring Measurement
Feature
Options
Description
Configure Update
Bios only, Entire Flash
BIOS only: Update BIOS Region, Entire Flash: Update Entire Flash
Preserve SMBIOS Variable
Enabled, Disabled
If Enabled, restore SMBIOS Variables (DMI Table) after Firmware
Update. In particular the board's UUID is preserved.
Preserve Boot Option
Priorities
Enabled, Disabled
If Enabled, restore Boot Option Priorities after Firmware Update.
This option does not restore the Advanced Boot Device Selection in
Boot Menu
Verbose Mode
Enabled, Disabled
If Enabled, Firmware Update displays some messages on the
console
Beep Mode
Enabled, Disabled
If Enabled, Firmware Update is reported by Beep Codes
Start Firmware Update
Enter
Press Enter to Start a Firmware Update. The BIOS Image has to be
placed into the correct directory.
Note: See section 8 for more information !