13. Projector Control
13.2 Individual Projector Address
About individual projector address
Before a projector, and only this projector, can be controlled via a remote control, an individual address must be entered in the
projector.
This individual projector address can then be used to control the projector via remote control or via a serial connection.
Next to an individual projector address, each projector has also a common address for group control.
How to set the address
1. Press Menu to activate the menus and select Projector Control → Projector Address → P rojector A ddress.
Image 13-1
Main menu, projector control
Image 13-2
Projector control, projector address
Image 13-3
Projector address
2. Press ENTER to activate the address input.
Image 13-4
Projector address, input
3. Use the ▲ or ▼ key to change the selected character.
Use the ◄ or ► key to select another character.
Note: Digits can b e entered with the digit k eys on the remote control or the local keypad. W hen a digit is entered in that way,
the next character will be selected autom
atically.
R5905032 HDX SERIES 01/06/2011
227
To Next Page
Loading...
