13. Projector Control
13.8.1 Standby button
What can be done ?
When going to standby by pressing the standby button, the following can happen:
• Only lamp will be switched off
• Lamp will be switched off and projector electronics will be powered down (ECO standby)
In ECO standby only the microcontroller, communication interface and local (or remote) control are operational. All other electronics
are powered down.
How to set
1. Press Menu to activate the menus and select Projector Control → Buttons → S tandby.
Image 13-69
Main menu, projector control
Image 13-70
Projector control, buttons
Image 13-71
Buttons, standby
2. Press ENTER to toggle between [Lamp only] and [Lamp and Power].
Lamp only : only lamp will be switched off when Standby is pressed. Other electronics remain powered.
Lamp and Power : lamp will be switched off and projector will be powered down.
256
R5905032 HDX SERIES 01/06/2011
To Next Page
Loading...
