13. Projector Control
13.6 IR Control switching
What can be done ?
Each IR receiver inside the projector can be activated or deactivated. When an IR receiver is deactivated, no IR signal send to this
IR receiver will be processed.
How to activate or deactivate
1. Press Menu to activate the menus and select P rojector Control → IR control.
Image 13-48
Main menu, projector control
Image 13-49
Projector control, IR control
Image 13-50
IR control
2. Use the ▲ or ▼ key to select the desired IR control and press ENTER to check checkbox.
Checked : IR receiver is enabled and can receive and process commands send by the remote control.
Not checked : IR receiver is disabled and not receive any command.
248 R5905032 HDX SERIES 01/06/2011
To Next Page
Loading...
