5. Getting started
5.3 Power on projector
How to power on.
1. Press the power switch at the back of the projector to switch on this projector.
Image 5-2
Main switch
- When ’0’ is pressed, the projector is switched off.
- When ’1’ is pressed, the projector is switched on.
The projector starts up in standby. The menus are accessible via the local LCD panel.
The start up screen is displayed on the local LCD panel and when f
ully started up, it changes to the overview screen.
Image 5-3
Start up screen, Main
This screen indicates :
- the selected Main input
- the selected PIP input
- the IP address
- the Customer Id
- the Lamp status
- the Mains voltage
- the current ambient temperature
- the Text status (OSD)
To display an image, the standby key must be pressed once.
R5905032 HDX SERIES 01/06/2011
65
To Next Page
Loading...
