Basler GigE SERIES User Manual

AW00089317000 Standard Features
Basler ace GigE 227
These parameters are included in each sequence set:
* This parameter is available for timer 1.
**This parameter is only available in auto sequence advance mode.
Sequence Set Configuration
Before the sequencer feature can be used you must populate the sequence sets with the parameter
values of the sequence parameters and store the sequence sets in the camera’s memory. Each
sequence set is identified by a sequence set index number starting from zero. After storing, the
sequence sets are available for use by the sequencer feature.
Some sequence advance modes require the storing of additional settings, for example, the total
number of sequence sets you want to use, the number of consecutive uses of a sequence set or
the source to control sequence set advance. For details about populating sequence sets and
making related settings, see the sections below explaining the sequence advance modes.
Gain
Black Level
Pixel Format
Test Image
Width
Height
X Offset
Y Offset
Center X
Center Y
Binning Horizontal
Binning Vertical
Decimation Vertical
Enabled Stacked Zone Imaging
Processed Raw Enable
Color Transformation Value
Color Transformation Matrix Factor
Exposure Time
Color Adjustment Enable
Color Adjustment Hue
Color Adjustment Saturation
Chunk Mode Active
Chunk Enable
Timer Delay*
Timer Duration*
Timer Delay Timebase*
Timer Duration Timebase*
Sequence Set Executions**
Reverse X
Reverse Y
Enable Acquisition Frame Rate
Acquisition Frame Rate
Sync User Output
LUT Enable

Basler GigE SERIES Specifications

General

Interface	GigE
Lens Mount	C-Mount, CS-Mount
Sensor	CMOS
Mount	C-mount, CS-mount
Power Supply	Power over Ethernet (PoE)
Dimensions	Varies by model
Weight	Varies by model
Operating Temperature	Varies by model