baxter TruSystem 7000 - Information Notices and Symbols

Safety
18
7990044_030_10 – 2078511 – 2023-01-19
2.7.3 Reset
If the operating table reacts unexpectedly to a control, switch off
the operating table and switch it back on. If you cannot even
switch it off, press the reset button. The reset button [23] is
located at the head end on the column base, directly below the
cladding. Remove the cover cap [24] (made of plastic) and press
the button [23] briefly using a pointed object (e.g. a ballpoint pen).
Then switch the operating table on again. With an external power
supply, the operating table switches on again automatically.
2.7.4 Failure of the operating table's electrical functions
According to the current market state of the technological art,
failure of the operating table cannot be completely ruled out, with
the result that the electrical functions on the operating table are
no longer available. In this rare case, stop using the operating table
and notify Technical Customer Service.
2.8 Information notices
2.8.1 Safety instructions
– The information notices on the product provide information
about residual dangers during use, or provide additional useful
information.
– The device label and all information notices must be present
and be undamaged in the prescribed locations on the product.
A damaged, illegible or missing device label / information
notice must be replaced immediately.
– Observe the information notices on the product.
– The information notices must not be altered or removed.
24
23