Description
26
7990044_030_10 – 2078511 – 2023-01-19
3.3 Summary of control modules
The operating table can be adjusted using the following control
modules:
–Column keypad
The column keypad allows you to use the basic functions of the
operating table.
– Remote control
The remote control is absolutely necessary for using the
operating table to its full potential.
–Footswitch
Entries via keys on the individual operating units are accepted in
the following priority sequence:
1. Column keypad
2. Cable remote control
3. Footswitch
4. Cordless remote control
Simultaneous activation of multiple keys will result in the sounding
of alarms or in the execution of table functions in order of priority.
3.3.1 Column keypad
The operating table is displayed on the column keypad in
simplified graphical form. The top section of the graphic
representation shows the functions of the operating tabletop,
with the functions of the operating table column below (viewed
from the head end). The keys for the adjustment functions are
identified by arrows and located on the corresponding table
segments. The direction of movement for the individual functions
corresponds to the image displayed.
The individual functions on the column keypad can only be
selected once the keypad is unlocked. To adjust an operating
table, press and hold the function key on the keypad until the
desired position is reached. The function stops when the key is
released. The keypad is locked again automatically ten seconds
after the last key press. The OFF key is the exception. The
operating table can be turned off at any time using the OFF key on
the column keypad.
The column keypad functions can also be selected using two-key
control. Press the ON key and simultaneously press the function
key required. The keypad does not need to be unlocked prior to
two-key control.
To Next Page
Loading...
Need help?
General
