Belanger CUBE - Load Position Photo-Eyes

Cube
®
Installation & Startup
9-6 Belanger, Inc. * PO BOX 5470. * Northville, MI 48167-5470 * Ph (248) 349-7010 * Fax (248) 380-9681 1MANUL963
Chapter 9 Photo-Eyes
Load Position Photo-Eyes
Equipment Included
Item
Quantity
Receiver Assembly
2
Emitter Assembly
2
Photo Eye Placement
Overview
The Load Position Photo-Eyes consists of two sets of Photo-Eyes, in the Exit Photo-Eye
Zone, working together to position the vehicle within the wash bay before the wash is
activated. When a vehicle enters the bay an In-Bay Sign will inform the customer to pull
forward, once the vehicle crosses the light beam from the first Photo-Eye the Sign will instruct
the driver to Stop. If the customer crosses the second Photo-Eye the Sign will instruct the
customer to Back Up. Once the vehicle is in the proper position the Cube® will be activated
and the wash cycle will begin.
Receivers on
Passenger Side
Emitters on
Driver Side
Exit
Entrance
Refer to the images on the following page
for positioning dimensions of the Load
Position Photo-Eyes.