Cube
®
Installation & Startup
1MANUL963 Belanger, Inc. * PO BOX 5470. * Northville, MI 48167-5470 * Ph (248) 349-7010 * Fax (248) 380-9681 5-11
Chapter 5 Getting Started
Cube® Utility Supplies Recommendations
The following is a list of hardware and/or utility supplies needed to successfully install a Cube® floor
mounted system.
We recommend using the following:
• 3/8” anchors to mount the ICS panel and Signs
• Hose clamps and tie wraps are also suggested for your convenience.
Note: See the chart that follows for a list of needed parts.
➢ All the items in the chart below can be purchased through the Belanger® Aftermarket group,
using the referenced part numbers.
➢ The quantity for each of the Hoses is based on the distance from the Utility Manifold to the
Back-Room Equipment which will vary per site. Measure this distance and specify the
amount needed per foot when ordering.
To Next Page
Loading...
