Cube
®
Installation & Startup
1MANUL963 Belanger, Inc. * PO BOX 5470. * Northville, MI 48167-5470 * Ph (248) 349-7010 * Fax (248) 380-9681 19-3
Chapter 19 Initial Startup Procedure of Cube®
3) Load ShineMitt® Cleaning Material onto Hubs
3a) Load ShineMitt® onto the Side Wheel Hubs
1) Locate ALL the ShineMitt® Cleaning Material. Included are two different lengths of the
ShineMitt® in varying amounts. There are 160 pieces of the 19” ShineMitt® (111060), 32
pieces of the 22” ShineMitt® (111053).
2) To make it easier to install the ShineMitt® onto the Side Wheel Hubs use tie straps to
compress and secure the Shaft Boots up and out of the way on the Shafts.
Note: It is imperative that the ShineMitts® cleaning material is loaded onto the driver side and
passenger side Side Wheel Hubs in the directions specified to properly clean vehicles and to
prevent damage to the equipment and/ or vehicles.
To Next Page
Loading...
