Belanger CUBE - Page 191

Cube
®
Installation & Startup
1MANUL963 Belanger, Inc. * PO BOX 5470. * Northville, MI 48167-5470 * Ph (248) 349-7010 * Fax (248) 380-9681 15-1
Chapter 15 Water Softener Option
Water Softener
The Cube® can operate using a 28GPM water softener.
A base Cube® can operate using the 213S OD / WA model (2 tanks). See the image below.
If the optional High Pressure (HP) Pump Assemblies have been purchased, another 28GPM water
softener is required. In this scenario, the 4-tank water softener model 213S OD / WB is necessary to
soften the water. See the image below.
The water softening scenarios above do not include supplying the RO Spot-Free Rinse. A Pur-Clean™
RO unit does not require softened water.
Model 213S OD / WA: 2-Tank System
Model 213S OD / WB: 4-Tank System
Out to Cube® ICS
Out to HP Pump
Assembly #2
Out to Cube® ICS
Out to HP Pump
Assembly #1
Non-softened water in
This line MUST be between
1-1/2” to 2” @ 40PSI.
Non-softened water in
These lines MUST be between
1-1/2” to 2” @ 40PSI.