185
Troubleshooting
lower feed dog
incorrect presser foot for BERNINA
Dual Feed switched on
winding a bobbin
too much fabric under presser foot
⦁
press «Feed dog»-button. Feed dog is lowered
⦁
attach a «D» presser foot
⦁
wind bobbin as shown in the animations
⦁
reduce amount of fabric under presser foot
incorrect needle for the stitch plate
selected
needle is not in the highest position
main motor is not running
⦁
check settings in securing programs
⦁
turn the handwheel
⦁
check hook system. Remove any thread lint from the hook
area/bobbin case
⦁
remove the hook and check the magnetic back of the hook
for broken off needle parts
opper thread run out
lower thread indicator has reacted
⦁
attach new upper thread spool and thread
⦁
check lower thread and wind if necessary
Stitch number not known in direct entry
Stitch selection not possible in the
combination mode
⦁
check command entered and enter a new number
⦁
make another selection
General Explanation Repair
Messages
To Next Page
