BK Vibro VIBROCONTROL 6000 - Configuration Parameters; Display Parameters; Parameter Summary; Parameters and Setup Ranges

MIN-HOLD measurement Part C VC-6000
TM
Compact monitor
© VC-6000
TM
Compact monitor Sept.2011 C100583.002 Components Vers. 07 - 49 -
16.2 Parameters and setup ranges
16.2.1 Display parameters
♦ <Min value>
Corresponds to the actual stored value.
Min value
Current value
♦ <Unit>
The unit parameter is determined by the application firmware creation
and can only be changed by a new firmware download.
Unit m/s², g, in/s², mm/s², mm/s in/s, mm, µm,
mils, eu, 1, C, F, K, V, BCU, R, s, mA, in,
rpm, Hz, cpm,
16.2.2 Configuration parameters
♦ <Reset>
The Reset parameter deletes the currently saved MIN-HOLD value so
that a new minimum value can be saved. The parameter can be
activated via the OPC-server or a BINARY-IN.
Reset Yes No
16.2.3 Parameter summary
Parameter name Setup range adjustable
Min value Display only No
Unit m/s², g, in/s², mm/s²,
mm/s in/s, mm, µm, mils,
eu, 1, C, F, K, V, BCU,
R, s, mA, in, rpm, Hz,
cpm,
No
Reset Yes / No Yes