Digital Communication Part A VC 6000
TM
Compact monitor
© VC 6000
TM
Compact monitor Juni 2014 C100575.002 Introduction Vers.10 - 36 -
10 Digital Communication
The VIBROCONTROL 6000 Compact monitor is able to export its
continuously acquired measurement data also as digital data. For this
purpose an OPC interface, which can optionally be integrated in a TCP/IP
Ethernet network, is available. With this function the VIBROCONTROL 6000
Compact monitor is a data source which makes your measured data and
status information available to a OPC-server (OPC DA-server – Type 7131)
in a prepared form.
Through the use of the OPC-interface it is possible to pass the data further
to process visualization systems.
For the data transfer the SCI-interface of the VIBROCONTROL 6000
Compact monitor
is used together with an RS-232 converter (AC-5004).
If the VIBROCONTROL 6000 Compact monitor
is connected to a network, a
Gateway (AC-5002) is also required.
Detailed information about the SCI-interface can be found in section
B – Basic module.
Infomation about the configuration of this interface can be found in section
C – COM-Block.
Infomation about the OPC-server can be found in the OPC DA-server –
Type 7131 handbook.
Infomation about the RS-232 converter is found in the AC-5003 data sheet.
Information about the Gateway is found in the AC-5002 data sheet.
To Next Page
Loading...