Parameter configuration sheet Part A VC 6000
TM
Compact monitor
© VC 6000
TM
Compact monitor Juni 2014 C100575.002 Introduction Vers.10 - 9 -
6 Parameter configuration sheet
The parameters that are preset in the basic configuration are entered in the
parameter setting sheet. If the preset parameters are changed with the use
of the User Terminal, the changes can be entered on the parameter setting
sheet in a further column.
♦ Each component is listed with its parameters and pre-defined settings.
♦ Each component of the input or output modules has a parameter
<socket number>. These particulars identify the physical socket number
for the components. This information is needed to assign the connection
plugs.
♦ The displayed parameters can all be displayed on the User Terminal.
Parameters which cannot be edited are displayed the following way:
[Hardware id.]. All other parameters can be edited.
♦ The meanings and functions of the parameters, and their setting ranges
are described at the corresponding locations. (see section C:
Components of the signal-flow chart)
To Next Page
Loading...