Mounting and Installation Part A VC 6000
TM
Compact monitor
© VC 6000
TM
Compact monitor Juni 2014 C100575.002 Introduction Vers.10 - 22 -
9 Mounting and Installation
9.1 Safety advice
The general safety advice of Brüel & Kjær Vibro GmbH is
applicable.
♦ The safety advice must be read and understood before putting the
instrument into operation!
♦ All installation work must be carried out without power to the instrument!
♦ If parameters setting changes are to be carried out during operation,
you should take into consideration the effect of the changes on the
active monitoring function!
♦ Switch off the power to the instrument before cleaning!
The instrument can be cleaned using a damp cloth. Do not spray water
or any other fluids onto the instrument!
♦ Connect only the power specified on the name plate!
♦ All cables must be laid out in such a manner that they cannot be
damaged!
♦ Observe all grounding instructions for the instrument and screened
cables!
♦ Electro static discharge upon the connectors may cause damage!
♦ CAUTION! The voltage supply may be connected only by isolating
equipment (e.g. a switch or circuit-breaker).The device used an an
isolator must fulfil the requirements of IEC 60947-1 and IEC 60947-3
and be suitable for the application.
To Next Page
Loading...