Safety advice Part A VC 6000
TM
Compact monitor
© VC 6000
TM
Compact monitor Juni 2014 C100575.002 Introduction Vers.10 - 3 -
1 Safety advice
This operating instruction document contains information and advice which
must be observed for the installation and operation of the VIBROCONTROL
6000 Compact monitor .
Please read these operating instructions carefully before installing a
VIBROCONTROL 6000 Compact monitor
and putting it into operation!
Please read the Safety requiements and Grounding recommendations
before installing and putting it into operation!
The Safety requierments and Grounding recommendations are given
separately with this manual.
Design concept application
A VIBROCONTROL 6000 Compact monitor is exclusively conceived for
measuring and monitoring vibrations, operating speeds and DC
measurements in the discipline of machine protection and condition-
dependent machine maintenance.
Any application outside of this conceptual scope is not considered valid.
Operational safety
A VIBROCONTROL 6000 Compact monitor is an operationaly secure
instrument and corresponds to the most modern standard of technology.
Each instrument leaves our works in a fault-free and safe condition.
Any person executing the installation or operation of the instrument must
have read and understood the operating instructions and especially the
safety advice notes.
The operational safety of the instrument cannot be guaranteed in the case of
improper procedures or non-observance of the operating instructions.
Warning note
Advice is given in the operating instructions concerning possible risks and
danger during installation and commissioning. This advice is emphasised by
the following:
Caution
Caution advises that by not observing the safety instructions the
possibility of danger to property and persons exists.
Commisioning!
Commissioning may only be performed by trained personnel!
To Next Page
Loading...