Blackmagic Micro Studio Camera 4K G2 - Page 76

Setup
If you have more than one Micro Studio Camera 4K G2 camera, you may wish to give each unit
a discrete name to make them easy to identify. You can do this by entering a new name into the
name field and clicking the ‘set’ button. It’s worth noting that changing the name of the camera
will invalidate any digital certificates in use, so it’s worth changing the name before generating
a certificate signing request or self signed certificate. More details on digital certificates are
available in the ‘secure certificate’ information later in this section of the manual.
Date and Time
Set your date and time automatically by ticking the ‘set date and time automatically’ checkbox.
When this checkbox is enabled, your camera will use the network time protocol server set in
the NTP field. The default NTP server is time.cloudflare.com, but you can also manually enter
analternate NTP server and then click on ‘set’.
If you are entering your date and time manually, use the fields to enter your date, time and time
zone. Setting the date and time correctly ensures your recorded clips have the same time and
date information as your network and also prevents conflicts that can occur with some network
storage systems.
Network Settings
Protocol
To control your camera remotely via Ethernet, or when connected to ATEM Television Studio
HD8 ISO as a remote source on your network, the camera needs be on the same network as
your other equipment using DHCP or by manually adding a fixed IP address.
76Blackmagic Camera Setup