Bosch DB18C3100R2 - Page 64

64 en | Default Configuration DiBos/DiBos Micro
F.01U.033.308 | V7 | 2009.09 Installation Guide Bosch Sicherheitssysteme GmbH
Audio: Activate this check box if audio is also to be recorded along
with this job.
Note:
The audio input must be assigned to the camera. This is done
under Video and audio connections Add or modify
camera General settings Audio input.
Pre-alarm time [sec.]: Select the pre-alarm time for the alarm and motion recording.
Note:
The maximum pre-alarm time is 1800 seconds. The pre-alarm
time depends on the recording rate of the pre-alarm
recording. A maximum of 3600 images can be recorded for
each pre-alarm and by each camera. Example: 1image/
second = 1800 seconds, 2 images/second = 1800 seconds,
4 images/second = 900 seconds, 5 images/second =
720 seconds etc.
Post-alarm time
[secs.]:
Enter the post-alarm time.
Note:
The maximum post-alarm time is 999 seconds. The default
setting is 0 seconds.
3 Motion recording Make the settings for motion recording.
Rate: Select the recording rate.
Quality: Select the recording quality.
Audio: Activate this check box if audio is also to be recorded.
Pre-alarm time [sec.]: Select the pre-alarm time for the alarm and motion recording.
Note:
The maximum pre-alarm time is 1800 seconds. The pre-alarm
time depends on the recording rate of the pre-alarm
recording. A maximum of 3600 images can be recorded for
each pre-alarm and by each camera. Example: 1image/
second = 1800 seconds, 2 images/second = 1800 seconds,
4 images/second = 900 seconds, 5 images/second =
720 seconds etc.
Post-alarm time
[secs.]:
Enter the post-alarm time.
Note:
The maximum post-alarm time is 999 seconds. The default
setting is 0 seconds.
4 Pre-alarm recording Make the settings for pre-alarm recording.
Rate: Select the recording rate for the pre-alarm time. The
recording rate applies to alarm recording and motion
recording.
Quality: Select the recording quality.
Audio: Activate this check box if audio is also to be recorded.