Bosch Solution 6000-IP Installation Guide

Solution 6000-IP  Installation Manual  Comms Programming
9-3
Bosch Security Systems 10/22 BLCC615I
REPORTING OPTIONS
Comms > Reporting >
TX Format Dest 1

MENU 5-4-0
0 1
00 - Disabled 01 ~ 12 Reserved
13 - Ethernet/WiFi 14 - GPRS IP
15 - MyAlarm IP
This menu allows you to program the transmission format
or language the panel will use to send event reports to
Destination 1. The panel has two separate destinations
that reports can be sent to and each one can be set to
use a different transmission format depending on the
application.
At factory default, all reports are routed to Destination 1.
1) Press [MENU] + [5] + [4] + [0]. The keypad will
display the current Transmission Format for
Destination 1.
TX Format Dest 1
01 - Contact ID PSTN
Press  0-9 OK to SAVE
2) Use the up and down arrow keys to select the
Transmission Format required then press [OK] to
save and exit or press [MENU] to exit without
saving.
Comms > Reporting >
TX Format Dest 2

MENU 5-4-1
0 1
00 - Disabled 01 ~ 12 Reserved
13 - Ethernet/WiFi 14 - GPRS IP
15 - MyAlarm IP
This menu allows you to program the transmission format
or language the panel will use to send event reports to
Destination 2.
1) Press [MENU] + [5] + [4] + [1]. The keypad will
display the current Transmission Format for
Destination 2.
TX Format Dest 2
01 - Contact ID PSTN
Press  0-9 OK to SAVE
2) Use the up and down arrow keys to select the
Transmission Format required then press [OK] to
save and exit or press [MENU] to exit without
saving.
Comms > Reporting >
Test Route

MENU 5-4-2
00 - Log Events Only 0 1
01 - Dest 1 + Log
02 - Dest 2 + Log
03 - Dest 1 & 2 + Log
04 - Dest 2 If 1 Fails
(*** System Wide Parameter ***)
This menu programs which destination will be used to
send both manual and automatic test reports.
1) Press [MENU] + [5] + [4] + [2]. The keypad will
display the current Test Route.
Test Route
01 - Dest 1 + Log
Press  0-9 OK to SAVE
2) Use the up and down arrow keys to select the Test
Route required then press [OK] to save and exit or
press [MENU] to exit without saving.
Comms > Reporting >
System Route

MENU 5-4-3
00 - Log Events Only 0 1
01 - Dest 1 + Log
02 - Dest 2 + Log
03 - Dest 1 & 2 + Log
04 - Dest 2 If 1 Fails
(*** System Wide Parameter ***)
This menu sets the report destination that will be used to
send all system event reports.
1) Press [MENU] + [5] + [4] + [3]. The keypad will
display the current Status Report route.
System Route
01 - Dest 1 + Log
Press  0-9 OK to SAVE
2) Use the up and down arrow keys to select the Test
Route required then press [OK] to save and exit or
press [MENU] to exit without saving.

Bosch Solution 6000-IP Specifications

General

Event Log	Yes
Areas	1
Partitions	1
Outputs	2
Communication	IP, GSM
Mobile App	Yes
Automation	Yes
System Type	Hybrid
Battery Backup	Yes
Keypads	Up to 8