Bosch Solution 6000-IP - Delete Token; Token Status; Edit Token

Solution 6000-IP  Installation Manual  Access Programming
5-5
Bosch Security Systems 10/22 BLCC615I
2) Swipe the token card past the reader. As you swipe
the token, the reader will sound a single beep to
confirm that the token has been learnt.
To add token for Ur1
John Smith present new
token
Press OK or MENU
i
Note
If the Add Token command is initiated from a keypad
that does not have a built in reader, you will need to
select a reader from the list before proceeding. Swipe
the Token at the selected reader.
Access > Token >
Delete Token

-

MENU 1-2-1
This menu allows the installer or master user to delete an
existing user’s token ID.
1) Enter [MENU] + [1] + [2] + [1] and use the up and
down arrows to highlight the user in the list then
press [OK]. The keypad will only display users that
have tokens assigned to them.
Ur1 John Smith
Ur2 Debbie Smith
Ur3 User 3 Name
Press  OK or MENU
2) Press [OK] to delete the token or press [MENU] to
exit without saving.
Press OK to Delete Token
For Ur1
John Smith
Press OK or MENU
Access > Token >
Token Status

-

MENU 1-2-2
This menu allows the installer or master user to identify
which user a token has been assigned to. You will need to
have the token in order to do the test. This menu can only
be performed at a prox keypad.
1) Enter [MENU] + [1] + [2] + [2]. The keypad will
prompt you to swipe the token to be checked.
Present Token to be
Identied
Press OK or MENU
2) Present the token to the keypad, you will hear a
confirmation beep and the display will show the
token status.
Token belongs to Ur2
Debbie Smith
Press OK or MENU
3) To exit, press [OK] or [MENU].
Access > Token >
Edit Token

-

MENU 1-2-3
This menu allows the installer or master user to view or
change the token ID for any user.
1) Press [MENU] + [1] + [2] + [3] and use the up and
down arrows to highlight the user in the list, then
press [OK].
Ur1 John Smith
Ur2 Debbie Smith
Ur3 User 3 Name
Press  OK or MENU
2) The keypad will display the current token ID of the
user selected.
Edit Token Ur1
0000000000
Press 0-9 OK to SAVE
3) Press [OK] to save and exit or press [MENU] to exit
without saving.