Bosch Solution 6000-IP Installation Guide

Solution 6000-IP  Installation Manual  Comms Programming
9-12
Bosch Security Systems 10/22 BLCC615I
UDP User RAS
This option allows the control panel to communicate
using the UDP internet protocol (User Datagram
Protocol) when the user remotely connects via Solution
Link software.
If this option is not programmed, the control panel will
use the TCP IP protocol.
Abort RAS On Alarm
If this option is programmed, the remote RAS connection
between the panel and the remote upload / download
computer will be terminated if panel registers an alarm
that needs to be reported.
Allow User Functions
Setting this option allows access to user functions via
the RAS upload/download software. If this option is not
programmed, user functions will be disabled.
Comms > IP Remote Access >
RAS Lockout Time

MENU 5-7-3
0 6 0
Seconds
This menu allows the control panel to lockout and prevent
the ability for anyone to remotely connect to the system
using the RAS IP connection method. During the lockout
time, (1 to 255 seconds / 0 = No Lockout), the system
will not respond to any TCP IP connection requests. The
lockout count is set at 6 failed attempts (fixed) over a 60
second period).
1) Press [MENU] + [5] + [7] + [3]. The keypad will
display the current IP RAS Lockout time.
RAS Lockout Time
060 Seconds
Press 0-9 OK to SAVE
2) Using the numeric keys, enter the new IP RAS
Lockout Time, then press [OK] to save and exit or
press [MENU] to exit without saving. Valid entires
are 0 to 255 seconds.
Comms > IP Remote Access >
IPRS Address

MENU 5-7-5
1 Digits 12
2 0 2 1 2 9 0 8 3 0 5 8
This menu is reserved for factory use. Do not change
unless requested to do so.
1) Press [MENU] + [5] + [7] + [5]. The keypad will
display the current IPRS address.
DNS Address
202129083058
Press  OK to SAVE
2) Use the numeric keys [0] to [9] + [←] and [→] keys
to program the 12 digit IPRS address, then press
[OK] to save and exit or press [MENU] to exit
without saving.
Comms > IP Remote Access >
IPRS Port

MENU 5-7-6
0 7 7 0 3
This menu is reserved for factory use. Do not change
unless requested to do so. This menu must be 5 digits set
with the range of 0 to 65535.
1) Press [MENU] + [5] + [7] + [6]. The keypad will
display the current IPRS port.
IPRS Port
07703
Press  OK to SAVE
2) Use the numeric keys [0] to [9] + [←] and [→] keys
to program the IPRS port, then press [OK] to save
and exit or press [MENU] to exit without saving.

Bosch Solution 6000-IP Specifications

General

Event Log	Yes
Areas	1
Partitions	1
Outputs	2
Communication	IP, GSM
Mobile App	Yes
Automation	Yes
System Type	Hybrid
Battery Backup	Yes
Keypads	Up to 8