Solution 6000-IP
Installation Manual Programming Overview
4-10
Bosch Security Systems 10/22 BLCC615I
REMOTE ARMING QUICK ARM
If you forget to turn your system on, it may be possible for
you to remotely turn on your system using a touch tone
telephone if the remote arm option has been enabled by
your installer.
To remotely turn on your system, call the telephone
number that the control panel is connected to. When the
control panel answers the call, you will here 3 beeps in
accending frequency if the control panel is disarmed. To
turn on your control panel, press [0] + [#] on your touch
tone telephone. You will hear 3 beeps in decending order
when the panel arms.
All areas on the system will be turned All On regardless of
there condition when using the DTMF quick arm function.
DURESS OR SILENT ALARMS
A duress emergency alarm can be easily initiated via the
keypad if you are being forced to operate the system
against your will.
To initiate a duress emergency, enter your normal user PIN
followed by the last 2 digits of your PIN followed by the
ON or OFF key. See the following examples.
1) If your PIN is 2580, to send a duress report when
the area is off, enter, [2] [5] [8] [0] + [8] [0] + [OK] or
[ON].
2) If your PIN is 2580, to send a duress report when
the area is on, enter, [2] [5] [8] [0] + [8] [0] + [OFF].
To Next Page
Loading...
Need help?
General
