Solution 6000-IP
Installation Manual System Programming
11-13
Bosch Security Systems 10/22 BLCC615I
2) Using the arrow keys , select the start/stop period
required, then press [OK] to select. Each timezone
include 4 seperate start/stop periods that can be
programmed.
Period 1
Period 2
Period 3
Press OK or MENU
3) Use the up and down arrow keys to highlight the
option then press the [ON] key to enable or the
[OFF] key to disable. Repeat Step 2 until all options
are programmed as required.
Invert Period Logic
Master Edit Allowed
Reserved
Press OK ON OFF MENU
4) Press [OK] to save and exit or press [MENU] to exit
without saving.
Invert Logic
Setting this option will invert both the start time and
stop time of the period of the selected timezone. The
programmed start time will now be the stop time and
the programmed stop time will be the start time.
Master Edit Allowed
Setting this option allows a master user to edit the
timezone period. There are many instances where
altering a timezone can seriously alter the behaviour
of the system and only trained professional operators
should be allowed to perform this type of operation.
SYSTEM HOLIDAYS
The control panel has provision for up to 8 individual
holiday time periods which can be used to allow or deny
access to users or to operate outputs via timezones.
Holidays are defined by setting a start and stop date so it
is possible to create 1 system holiday that spans multiple
days. For example the holiday could start on the 1st Jan
and end on the 5th Jan.
System > Holidays >
Holiday Name
-
MENU 7-6-0
H o l i d a y 1 N a m e
This menu allows you to program a 20 character text name
for each holiday.
1) Press [MENU] + [7] + [6] + [0] and use the up and
down arrows to highlight the Holiday in the list
then press [OK]. Alternatively, you can enter the
Holiday number directly and press [OK].
H1 Holiday 1 Name
H2 Holiday 2 Name
H3 Holiday 3 Name
Press OK or MENU
2) User the arrow and number keys to move and
change text. When the Holiday Name is complete,
press [OK]. At any time you can press the [OFF] key
to clear the text from the current cursor position to
the end of the line.
Holiday Name H1
Holiday 1 Name
Press OK to SAVE
System > Holidays >
Start Stop Dates
-
MENU 7-6-1
Start 12am Stop 12am
01 Jan 01 Jan
DD MM DD MM
This menu allows you to program the start and stop date
for each holiday period. Holidays can be as short as one
day or as long as 364 days.
1) Press [MENU] + [7] + [6] + [1] and use the up and
down arrows to highlight the Holiday in the list
then press [OK]. Alternatively, you can enter the
Holiday number directly and press [OK].
2) Use the up and down arrow keys to select the
holiday that you want to change, then press [OK].
Alternatively, you can enter the holiday number,
then press [OK]. The keypad will display the holiday
start date:
Holiday Dates H1
Start 12am Stop 12am
01 Jan 01 Jan
Press OK to SAVE
3) To program, use the left and right arrows to scroll
the cursor left and right between the holiday day
and month options and use the up and down arrow
keys to scroll the day and month.
4) Press [OK] to save and exit or press [MENU] to exit
without saving.
If the start day and month equals the stop day
and month then no holiday exists. There must be a
difference between start and stop dates.
To Next Page
Loading...
Need help?
General
