82
Section 3. Using effects
The Mastering Tool Kit’s algorithms are
composed from the following effects.
INPUT
3BAND COMP
MIXER
LIMITER
OUTPUT
This compresses the overall output signal when
the input volume level exceeds a set value.
On/Off OFF, ON
This parameter turns the compressor effect on/
off.
Lo Threshold -24 – 0 dB
This sets the volume level at which the lower-
range compressor goes into effect.
Lo Ratio 1:1.00 – 1:16.0, 1:INF
This sets the ratio of suppression of the lower-
range output when the input level exceeds the Lo
threshold level.
Lo Attack 0 – 100 ms
This sets the time it takes for the lower-range
compressor to go into effect once the input level
exceeds the Lo threshold level.
Lo Release 50 – 5000 ms
This sets the time it takes for the lower-range
compressor effect to stop once the input level
falls below the Lo threshold level.
Mid Threshold -24 – 0 dB
This sets the volume level at which the midrange
compressor goes into effect.
Mid Ratio 1:1.00 – 1:16.0, 1:INF
This sets the ratio of suppression of the midrange
output when the input level exceeds the Middle
threshold level.
Mid Attack 0 – 100 ms
This sets the time it takes for the midrange
compressor to go into effect once the input level
exceeds the Middle threshold level.
Mid Release 50 – 5000 ms
This sets the time it takes for the midrange
compressor effect to stop once the input level
falls below the Middle threshold level.
Hi Threshold -24 – 0 dB
This sets the volume level at which the upper-
range compressor goes into effect.
Mastering Tool Kit
Algorithm List
MT BANK [MSTR TOOL KIT]
=[IN]=[CMP]=[MIX]=[LIM]=[OUT]=
Parameter List
3BAND COMP
MICRO-BR_e.book 82 ページ ２００９年５月２８日 木曜日 午後２時２６分
To Next Page
Loading...
