M710 User Manual 9
Setup
Printer Settings
3. Press to accept the choice and display the time and date settings.
4. For information on how to use the screen, see “Settings Screens” on page 28. Most of the
settings on this screen are self-explanatory, but the following information may be useful.
•
Display 24 Hour:
If this is selected, hours are numbered 1-24. Clear this field to number the
hours 1-12 and use AM and PM.
•
PM:
Not available if
Display 24 Hour
is selected. Clear this check box for AM; set it for PM.
5. Tap OK.
6. Press to dismiss the menu. Alternatively, use the navigation keys to navigate to the
next setting that you want to configure.
Pause/Cut
The Pause/Cut function allows you to remove a label from the printer before another label starts
printing.
To set pausing and cutting:
1. Press FN + SETUP.
2. Use the navigation keys to move through the menu until Pause/Cut is highlighted.
3. Use the up and down navigation keys to select the desired function.
•
End of Label:
The printer cuts after each label and then prints the next label.
•
End of Job:
The printer prints all labels in a file and then cuts. The next job (file) prints.
•
Never:
Always prints the next label or file in the queue without pausing. This is useful for
terminal block, patch panel, and 66-block labels.
4. Press to accept the choice.
Printer Configuration
Use the Config menu to set the brightness, automatic shutdown, backfeed, and to clean the printer.
To configure the printer:
1. Press FN + SETUP.
2. Use the navigation keys to move through the menu until Config is highlighted.
3. Press to accept the choice and display the printer configuration settings.
4. For information on how to use the screen, see “Settings Screens” on page 28.
•
Printer Name:
(Optional.) Tap in the
Printer Name
box and use the keyboard to type a name
for the printer. When using the Brady Express Labels app, this name is shown when selecting a
printer.
To Next Page
Loading...
