Troubleshooting and routine maintenance
C - 3
C
Paper Jam A1
Paper Jam A2
Paper Jam B
Paper Jam C
Remove the jammed paper. See the
alphanumerical diagram to check on
the location.
See Paper jams on page C-6.
Replace 120K Kit It is time to replace the 120K kit. Call your Brother dealer or Brother Customer Service
to replace the 120K kit.
Replace Fuser It is time to replace the fusing unit. Replace the fusing unit. (See Replacing the fusing unit
on page C-36.)
Replace OPC Belt It is time to replace the OPC belt
cartridge.
Replace the OPC belt cartridge. (See Replace OPC
belt cartridge message on page C-33.)
Replace PF Kit2 It is time to replace the PF kit2. Call your Brother dealer or Brother Customer Service
to replace the PF kit2.
Stacker Full The output tray is full of paper. Remove the paper from the output tray.
Toner Empty X
X = C, M, Y, K
The toner is used up and printing is
not possible.
Replace the used toner cartridge with a new one. (See
Replacing a toner cartridge on page C-29.)
Toner Error The machine has detected an
incompatible toner cartridge.
Use only Brother genuine toner cartridges.
Toner Low X
X = C, M, Y, K
The indicated colour toner is nearly
empty.
Order a new toner cartridge now.
Unable to Init.
Unable to Print
Unable to Scan
The machine has a mechanical
problem.
Turn off the machine's power switch and then on
again. If the error message continues leave the
machine for several minutes and then try it again. (The
machine can be turned off for up to 60 hours without
losing faxes stored in the memory. If the machine will
be off longer than 60 hours, you can save the faxes in
your PC. See Transferring faxes to your PC on page
C-4.)
Waste Toner Full The waste toner pack is full. Replace the waste toner pack. (See Replacing the
waste toner pack on page C-32.)
ERROR MESSAGES
ERROR MESSAGE CAUSE ACTION
To Next Page
Loading...
