6-70 Confidential
(6_60)
Paper feed motor harness
Encoder PCB support
PF encoder PCB
Screw, bind M2x12
PF encoder disk
Engine unit
PF encoder/
registration
sensor harness
PF roller gear L
Ejection idle gear
Ejection roller gear
Paper feed roller
(11) At the left end of the engine unit, remove the screw that secures the PF encoder PCB and its
support to the engine unit, taking care not to touch the PF encoder disk (if it has not been
removed in Section 6.1.16).
(12) If the PF encoder disk needs to be replaced, peel it off from the PF roller gear L.
NOTE: Once removed, the PF encoder disk will become unusable and a new disk will have to
be put back in.
NOTE: Remove any adhesive remaining left on the PF roller gear L.
Paper feed motor
(13) Remove the two screws from the left end of the engine unit and remove the paper feed motor
in the direction of the arrow.
(6_61)
Paper feed motor
Screw, bind M2.6x4
PF roller gear L
(Left)
Paper feed motor
harness
Engine unit placed
upside down
To Next Page
Loading...
Need help?
General
