User Manual 4 The ESPRIT 2 Software
32
corner of a configurator ( or icon
to access the corresponding
Fig. 4.5-3 Sample configurator
4.5-4 Sample configurator select entry
Fig. 4.5-5 Sample properties dialog
The Sample configurator is used to
manage information about the sample.
The
information displayed is divided into the following
parameters:
Sample type
Coating type
Company
Batch
Sample
The parameter to be displayed can be set by the us
er
by clicking with the right mouse key on the displayed
value in the configurator and selecting the desired
parameter in the Select entry menu.
When clicking on the icon in
corner of the Sample configurator, the S
pops up. Before measurement,
of the sample can be entered in
All subsequently collected data
(spectrum, image, line scan, map
parameters. Default input parameters are n
description. Additional user-
added clicking the icon.
Sample coating.
If the sample is coated to enhance
electrical conductivity, this can be entered
Sample coating.
None. Select this option, if the sample is not coated.
Coating with. Select this option, if the sample is coated.
Select the element of the coating material in the periodic
table which pops up after selecting this option. The
selected element will be considered for the peak
deconvolution algorithm but will not be quantified. The
display changes to Coating with “Element name”.
Coating calibration. Select this option, if the sample is
coated and a coating correction data file (.ccc) is
available. Open the *.ccc file in the popup dialog.
The Standards configurator is available, if a
standard-based EDS quantification license