Bruker QUANTAX EDS - Report; Project

User Manual 4 The ESPRIT 2 Software
38
WD spectrometer. If a WD spectrometer
is attached
to the system, it can be configured under the WDS
detector configurator. For details see the
QUANTAX
WDS User Manual and the
XSense Reference
Manual.
EBSD detector.
If an EBSD detector is connected, it
can be configured under the EBSD detector
configurator. For details see the
QUANTAX EBSD
Quick Reference Guide and the e
-
Flash R
eference
Manual.
X-ray source. If an X-
ray tube is connected, it can be
configured under the X-
ray source configurator. For
details see the QUANTAX Micro-
XRF User Manual
and the XTrace Reference Manual.
4.5.7
Report
Fig. 4.5-18 Report configurator
The Report configurator
shows the number of
opened reports, the number of pages,
objects and
the name of the selected report.
Clicking on the icon in the bottom left corner
of
the Report configurator opens the report editor.
Further details on how to use the report function
are
described in section 5.21.
4.5.8
Project
Fig. 4.5-19 Project overview
The Project tool se
rves as data clipboard for data
transfer between ESPRIT workspaces or save all
data added to Project as one file to disk (.rtx file
format
). Images, spectra, element selection,
quantification methods, result tables, map/phase
images, line scan data (includ
ing point spectra) can
be added to and stored in a project.
The Project
is either docked into the configurator bar
on the top of the screen or docked onto the right
side of the screen above the Report
/ Report
preview. The two positions of the Project (and
Report) can be toggled by clicking on the
icon
next to the project name. See section 5.22
for further
details.